Can you share the solution that worked for you? I quickly checked the Autodesk forum thread and could see at least two different solutions. :)
Sure
Solution 1 - disabling Status XYZ
macroScript DisableStatusXYZ
category:"DragAndDrop"
toolTip:""
(
toolmode.commandmode = #select
disableStatusXYZ()
)
This script works, but it disables Status display only until some transformation mode get active, so it needs to be used constantly during the working process.
Solution 2 - change mouse settings
If you are using gaming mouse you have to change your polling rate 1000hz to 125hz.
Solution 2 works fine for me