Old question about DR ...

[GabaCGStudio]

i have an old question about DR on old versions!

is the behavior of DR on bucket mode as like as V-Ray bucket DR?

[maru]

I don't think there is "bucket dr" and "regular dr" or "progressive dr". It just sends information from render nodes to the master. Buckets was a setting which only affected rendering.

Also I am not sure what you mean by "V-Ray bucket DR" since I am not familiar with it, and other users might not be familiar as well.

[GabaCGStudio]

I am not sure what you mean by "V-Ray bucket DR"

i mean 1st bucket processed by master ... 2nd bucket processed by slave1 ... 3rd bucket processed by slave2 ... and (n)th bucket processed by slave(n-1), and this circle (depend on bucket position/index on hilbert curve) to be continued until finish.

[maru]

I am almost sure that it did not work like that.

[GabaCGStudio]

well ... too bad :/

[alexyork]

Rather than starting a fresh thread, in 1.5 do corona regions now properly work with DR? Currently in 1.4 I can draw corona regions but they are ignored by DR nodes which continue to render the whole frame regardless.

[Ondra]

there is no change in this behavior between 1.4 and 1.5

[alexyork]

there is no change in this behavior between 1.4 and 1.5

Hope this one's on your list for 1.5.0.1 then? :)

[Monkeybrother]

there is no change in this behavior between 1.4 and 1.5

Hm. Is this something that is on the road map? We use region rendering pretty extensively where I work and it could be a deal breaker.

[Ondra]

well, I wanna say 1.6... lets see :D