111M Primitives inst and 46h render time. when using only 18 trees from IToo?!

[MSJ]

I don’t understand why all the stats are through the roof when I use a few trees or whatever in Forest Pack.

I really need someone to help me out!

See photo of the stats.

[romullus]

I can instantly decrease your estimated render time by 60 times - if you'd look closely, it's actually 46 minutes, not hours ;] I don't see anything out of ordinary in your scene stats. If it fits into available RAM, then you have nothing to worry about.

[HannesN]

Such a simple scene should reach noise level below 5 percent noise within a few minutes. What's are the specs from your machine and what did set as rendering goal  ?

[MSJ]

Is this the info you need?

I also think 46min (not hours) are alot. So i dont know what the problem is.

I wanted to se the stats under "scen" when render cuz the scene crashed and I wanted to know why. So i notice that all the stats was off the roof. But i dont know how to fix it.
The ground is just material, and only 18 IToo trees.

[MSJ]

Here is another photo of the machine

[romullus]

What resolution you are rendering to?

You can run Corona benchmark on your pc and compare its results with others with the same specs to see if there's anything wrong with your computer. https://www.chaos.com/corona/benchmark

[maru]

Yes, it would be good to know what resolution you are rendering to.

Other than that, you were able to render 5 passes in 2 minutes. That's 50 passes in 20 minutes, and that should be pretty good quality for this scene (it would probably require more passes in an interior).
Try using pass limit or time limit instead of noise limit.

[Nejc Kilar]

As another tip, if everything checks out fine with your hardware, is to make sure all the opacity maps on the leaves have "clip" toggled to on.