Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LUXi

Pages: [1] 2
1
issue...preview in the Surface window is black

@cucu change render engine then back and it will work...

4
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-02-06, 13:42:05 »
I've found the solution.
The negative sign is the issue. In 3D view is possible to adjust the lamp to negative side size
It should not be allowed the negative number.

5
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-02-05, 19:07:25 »
I got an issue with the new light.
See the attached file no emitting and the light is black.
The reference light is ok but not turnable to 90 degree


AC21HUN

6
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-02-04, 12:28:17 »
@rozky The message was: The assigned file is not lamp file. Please find a valid lamp file...it is translated roughly from Hungarian
BUT the AC21 version is OK!
THANK YOU!

7
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-02-03, 23:10:05 »
I know the steps File > Libraries and Objects > Library Manager...etc. but I got an error message.
Must be the my version HUN is the issue... I am going to try with INT version.

8
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-02-03, 17:27:51 »
I need your help on how to use gsm file?

9
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-01-30, 15:20:43 »
@alexhajdu if you are ready I will be happy to test it.

10
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-01-29, 17:53:37 »
...like this

11
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-01-29, 17:46:31 »
Alex, imagine a rectangle light on a vertical wall as tma presented.

12
[ARCHICAD] General Discussion / Re: Corona light settings
« on: 2020-01-29, 17:42:49 »
tma that is correct but how?

13
[ARCHICAD] General Discussion / Corona light settings
« on: 2020-01-28, 19:30:32 »
Hi all,

I need your help. I am struggling with settings of rectangle light to set the vertical position. How to do that?
Any help I could appreciate.

Thanks,
krsz

14
Hi,

I have got a new sequel. I think the problem is the graphic card. The issue is only with quadro cards but with gtx card everything is ok.
The video driver must be the source of trouble.

krsz

15
Hi all,

Before corona time this problem had existed...I think you should report this issue to Graphisoft... it is already been but just nothing happened so far.
Very hard to reproduce the problem, my experience is when a section tab is active and attempting to reserve the surface dialog then crash AC...

krsz

Pages: [1] 2