Messages

1

[Max] I need help! / Re: Noise reflection in mirror

« on: 2019-11-18, 14:34:07 »

- issue is in IR and also in production rendering
- used corona high quality denoising - turned it off - result is the same
- changed UHD Precision - it made rendering slower and the artifacts smaller
- ticking the Animation/Flicker free option - it worked (thank you Corona_GK and arqrenderz)

In attachment is the mirror material. Just to see if the culprit was the mirror.
Otherwise the issue can be considered as solved :-).

2

[Max] I need help! / Re: Noise reflection in mirror

« on: 2019-11-18, 06:46:29 »

Material setup is as simle as I could make it. Only added AO to mirror for better corner visibility. But tha does not affect the noise reflection.
Plus by glass partition I meant the physical glass wall dividing shower and the rest of the room :-).

3

[Max] I need help! / Noise reflection in mirror

« on: 2019-11-15, 21:31:24 »

Hi,
pls need some advice. Issue is with the glass reflection in mirror. There isn't any noise added in the glass or mirror materials. Caustic is turned off. Tried with portal and also without.
Noise appears in the mirror when I turn on the glass partition and disappear when its off.
Any probable causes?
THX

4

[Max] I need help! / Re: (Corona + Forest Pack) geometry disappears just before the end of rendering

« on: 2019-03-19, 13:48:56 »

Not sure if DR or Backburner. For distributed rendering I installed the Autodesk Backburner and Corona DrServer on other nodes (PCs). But I don't have Forest Pack on them. So later today I will try to install it and will see.
Thx for the suggestion.

5

[Max] I need help! / (Corona + Forest Pack) geometry disappears just before the end of rendering

« on: 2019-03-19, 12:01:21 »

Hi,
I have an issue with rendering in Corona while using Forest Pack.
The geometry disappears just before the end of rendering. While during the rendering the greenery was still visible.
Example in attachment.
Pls any advice?

Using:
3ds Max 2019
Corona Renderer 3 (Hotfix 1)
Forest Pack 6.1.5

6

[Max] I need help! / Re: Corona Render Loop

« on: 2019-03-05, 11:34:22 »

Quite correct.
It was an old file set up by someone else and I looked at everithing. Did not expect it would be this simple.
Much appreciated.
Have a great day :-). 

7

[Max] I need help! / [solved] Corona Render Loop

« on: 2019-03-05, 08:54:55 »

Hi,

pls need hepl with a render loop issue. Each time the rendering is stopped or finishes it starts again. I'm using a corona camera and there is nothing set in it on Multi-Pass effect.
I disabeled all batch rendering and still the issue prevails.

Thank you for response.