Messages

1

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-04-06, 21:45:16 »

works w/o issues on windows10, crn v8 rc3, c4d 25.117  (I just had to localize textures)

---------------------------------------------------------------------------------------------------------
PS
shortcuts are edited/made via "Command Manager"

I didn't see a solution to the problem in this video

2

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-04-01, 12:15:51 »

And how to make hotkeys for these commands "Stop" and "Start IR"

3

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-03-31, 16:30:39 »

What should I do now?
I have all models made this way , behave like this . Before that, I used Octane render, there was no such thing.

4

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-03-31, 09:17:44 »

Friends, what do you say? You have a scene displayed normally?

5

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-03-30, 09:05:50 »

Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.

here is the scene

6

[C4D] I need help! / Re: Corona Renderer IR is wrong

« on: 2022-03-30, 09:03:53 »

I don't know about you, but I still get the problem of the IR or IV not updating and have to hit Stop and re-enable it. did you start flat, move your joints and THEN it still showed flat?

from the very beginning, everything was fine. After I do something with the model, move the joint or just rotate the model, it becomes flat. In order for it to look like folded again, you need to restart the IR.

7

[C4D] I need help! / Corona Renderer IR is wrong

« on: 2022-03-28, 19:28:45 »

Hello!
I observe such an effect, There is one thing in the viewport, Interactive Render shows the model without affecting it with joints

помогает только перезапуск IR