Chaos Corona Forum

General Category => General CG Discussion => Topic started by: aaouviz on 2024-11-27, 08:26:46

Title: 3dsmax invert
Post by: aaouviz on 2024-11-27, 08:26:46

**Not corona related**

In 3dsmax...

I can do ctrl + i on an edit poly modifier to invert the selection, but I can't do the same when in edit mesh mode. Why?

It seems I can't set this hotkey to the edit mesh either. Why?

Any help much appreciated :)

Title: Re: 3dsmax invert
Post by: James Vella on 2024-11-27, 09:16:30

Works for me.

Title: Re: 3dsmax invert
Post by: aaouviz on 2024-11-27, 09:19:23

Hmm, good to know. Thanks for the reply James.

I'm currently on 2025, but this has always plagued me across all versions (as far as I can remember).

Title: Re: 3dsmax invert
Post by: James Vella on 2024-11-27, 09:29:41

Just tested in both 2021 and 2024 works the same for me. Edit mesh as a modifier and Editable mesh (converted)

Title: Re: 3dsmax invert
Post by: aaouviz on 2024-11-27, 12:32:22

Thanks again for clarifying.

It seems my long-used hotkeys file is overwriting them.

Using the max default hotkeys fixes it. So I'll dig through my overrides and figure it out

:)

Thanks again, James.

Title: Re: 3dsmax invert
Post by: James Vella on 2024-11-27, 13:13:28

No worries, glad you pin pointed the issue.