Chaos Corona Forum

General Category => General CG Discussion => Topic started by: stellab on 2024-04-29, 09:51:54

Title: set up for print
Post by: stellab on 2024-04-29, 09:51:54

Hi all,
I;m new to archiviz field and I'm doing some image for fruniture's catalogue to be print. Can you please suggest me wich things I have to keep in mind and what is the better output for print a render?

thank you so much

Stella

Title: Re: set up for print
Post by: maru on 2024-04-30, 14:33:44

I don't think this is something that can be covered with a single forum post, or even ten. :)
Maybe you could explain what exact print this is going to be (what print method, size, etc). And maybe you have some specific questions or you are running into specific issues? It would probably be easier for anyone to reply to a specific issue or question than to just share all their knowledge on this topic.