Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] Bug Reporting => [Max] Resolved Bugs => Topic started by: higgledyhiggles on 2014-06-20, 12:28:50

Title: Rough Edge with Adaptive Splines
Post by: higgledyhiggles on 2014-06-20, 12:28:50

Getting a rough (garbled) edge on an adaptive spline with an extrude (logo). it goes away when set non-adaptive with higher steps instead.

Title: Re: Rough Edge with Adaptive Splines
Post by: Ondra on 2014-06-21, 23:38:30

Does not happen here, can you provide me a scene?

Title: Re: Rough Edge with Adaptive Splines
Post by: higgledyhiggles on 2014-07-19, 13:18:32

woops, let this report go a bit cold..
attached references. check the top right edge of the copright `R`.
 I checked again today (reinstalled A6) and it definitely happens in Alpha 6 so I loaded same scene and same settings in alpha 7 and it`s fine so maybe you already unknowingly fixed it ?
Let me know if you still need a look at the scene..

Title: Re: Rough Edge with Adaptive Splines
Post by: Ondra on 2014-07-19, 14:21:24

Yes, I would like the scene ;)

Title: Re: Rough Edge with Adaptive Splines
Post by: higgledyhiggles on 2014-07-20, 12:00:25

scene attached.
In Alpha 6 with adaptive or optimize spline on it`s looks weird, off and it goes away. Alpha 7 is ok too.
Spline was imported from .ai

Title: Re: Rough Edge with Adaptive Splines
Post by: Ondra on 2015-02-12, 21:01:57

the problem does not happen anymore