Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] I need help! => Topic started by: lupaz on 2023-01-25, 16:51:25

Title: [solved] Corona pattern. Automatic height
Post by: lupaz on 2023-01-25, 16:51:25

Hi,

Shouldn't "automatic height" keep the height proportionally correct regardless of mapping or tiling?
In this video I used a small cylinder as the node. But when on the pattern, it gets distorted in height.

Title: Re: Corona pattern. Automatic height
Post by: TomG on 2023-01-25, 17:00:01

Can depend on your source object's XForm and similar (that is, the one being repeated as the Pattern).

is the bit that explains the use of pattern height.

Title: Re: Corona pattern. Automatic height
Post by: lupaz on 2023-01-25, 18:17:51

Ok. Thanks Tom. I'll try resetting Xforms.

Title: Re: Corona pattern. Automatic height
Post by: maru on 2023-02-03, 10:07:14

Hi Lupaz, do you have any progress here? Is it working fine after xform reset?

Title: Re: Corona pattern. Automatic height
Post by: lupaz on 2023-02-03, 14:14:04

Yes. It worked.
Not sure why though, cause the cylinders where a standard Max geometry that I rotated in subobject level at one point, keeping 90 degrees always.
Thank you for checking in.

Title: Re: Corona pattern. Automatic height
Post by: maru on 2023-02-03, 14:54:29

Cool, thanks for confirming!