Chaos Corona Forum
Chaos Corona for Cinema 4D => [C4D] I need help! => Topic started by: Dimsn555 on 2022-03-28, 19:28:45
-
Hello!
I observe such an effect, There is one thing in the viewport, Interactive Render shows the model without affecting it with joints
помогает только перезапуск IR
-
Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.
(https://forum.corona-renderer.com/index.php?action=dlattach;topic=35986.0;attach=163234;image)
-
I don't know about you, but I still get the problem of the IR or IV not updating and have to hit Stop and re-enable it. did you start flat, move your joints and THEN it still showed flat?
-
I don't know about you, but I still get the problem of the IR or IV not updating and have to hit Stop and re-enable it. did you start flat, move your joints and THEN it still showed flat?
from the very beginning, everything was fine. After I do something with the model, move the joint or just rotate the model, it becomes flat. In order for it to look like folded again, you need to restart the IR.
-
Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.
here is the scene
-
Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.
here is the scene
This file is corrupt. Can you please ensure you are uploading a .c4d file?
-
This file is corrupt.
It's just a 7zip file without extension. Inside there is the C4D file (and two textures).
Good Luck
-
This file is corrupt.
It's just a 7zip file without extension. Inside there is the C4D file (and two textures).
Good Luck
Ah, you're right! Thanks Frood :)
-
Friends, what do you say? You have a scene displayed normally?
-
Just teststed in (Mac R20).
Viewport rendering did indeed show it flat. Then I used the corona IRR and that showed the box in its correct folded state.
Weirdly when i switched back to viewport rendering that was now showing correctly too.
I deleted the materials and it went back to being flat again.
So yeah, something is not refresing as it should.
-
What should I do now?
I have all models made this way , behave like this . Before that, I used Octane render, there was no such thing.
-
And how to make hotkeys for these commands "Stop" and "Start IR"
-
Nice font you're rockin there! ;) As for this, I do not think it's possible. But hopefully, someone will correct me.
-
works w/o issues on windows10, crn v8 rc3, c4d 25.117 (I just had to localize textures)
---------------------------------------------------------------------------------------------------------
PS
shortcuts are edited/made via "Command Manager"
-
Thanks burnin'
-
works w/o issues on windows10, crn v8 rc3, c4d 25.117 (I just had to localize textures)
---------------------------------------------------------------------------------------------------------
PS
shortcuts are edited/made via "Command Manager"
I didn't see a solution to the problem in this video
-
Of course not, because that's not C4D app but Corona's VFB (request for a feature) yet still, you can run/call IV, IR or VFB directly
(https://forum.corona-renderer.com/index.php?action=dlattach;topic=35986.0;attach=163527;image)
& then use standard:
Esc > Stop rendering
Alt+F4 > Close window
Finally, there's Cinema's "Interactive Render Region" (Alt+R) which runs in viewport whatever engine you have set (but responds like one lazy mofo).