Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] General Discussion => Topic started by: clonk2u on 2014-03-30, 03:54:57

Title: Displacement Water level spinners purpose?
Post by: clonk2u on 2014-03-30, 03:54:57

Hello, in the CoronaMtl Displacement Section I see there is a greyed out spinner marked Water Level, is there any way to activate it/what does it do?  Sorry for short post and asking a question.

Title: Re: Displacement Water level spinners purpose?
Post by: Ondra on 2014-03-30, 12:07:50

it will be active probably in next version

Title: Re: Displacement Water level spinners purpose?
Post by: borisquezadaa on 2014-03-30, 17:25:02

"The water level option allows you to clip the surface geometry in places where the displacement map value is below the specified threshold. This is useful for clip mapping a displacement map value below which geometry will be clipped."

Title: Re: Displacement Water level spinners purpose?
Post by: hunter1st on 2014-04-07, 21:34:42

Iv noticed people using displacement on these forums but i cant understand how. I'm adding a black and white brick map in the displacement slot but it just goes crazy. is there a way to reduce the value?

Title: Re: Displacement Water level spinners purpose?
Post by: borisquezadaa on 2014-04-07, 21:42:25

The settings for displacement are in the basic options tab.