Chaos Corona Forum
Official Stuff => News => Topic started by: Ondra on 2014-03-27, 16:42:19
-
http://corona-renderer.com/wiki/3rdparty
Did I miss anything? Anyone knows aby any additional ones?
-
And Gugila GroundWiz too. But requires more memory than any multiscatter.
I tested it in A5 half a year ago.
-
I just got some word from Rebusfarm with promising news for Corona support. finally I can spend my credits again :)
-
A6 works fine with MultiMapID2 (tested in max 2012, there seems to be no 2013/2014 version of the map):
http://rpmanager.com/otherGear.htm#multiidmap (http://rpmanager.com/otherGear.htm#multiidmap)
Support for f-edge would be cool. It's probably easy to code by yourself but as long as there is no built-in alternative it would be great to support it:
http://www.ddag.org/products.html (http://www.ddag.org/products.html)
-
A6 works fine with MultiMapID2 (tested in max 2012, there seems to be no 2013/2014 version of the map):
http://rpmanager.com/otherGear.htm#multiidmap (http://rpmanager.com/otherGear.htm#multiidmap)
Support for f-edge would be cool. It's probably easy to code by yourself but as long as there is no built-in alternative it would be great to support it:
http://www.ddag.org/products.html (http://www.ddag.org/products.html)
You mean rounded corners feature in advanced rollout of CoronaMTL? :)
-
f-edge can be used as a bump map but it's also a more general map. It paints a gradient (user defined width and color) on edges - either all edges, edges in a selection set or sharp edges based on smoothing groups. Sharp edges is the most interesting option since it can be used for masking to get a worn out edges effect etc.
I guess you could also extend the Corona Edges Texmap to support this.
It is NOT the same as AO in invert mode.
-
I have a reply to my post on An(i)ma forum, they will support corona on next update
in May