Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] I need help! => Topic started by: mwg on 2019-09-12, 10:16:09

Title: Region Render Help
Post by: mwg on 2019-09-12, 10:16:09

Hi everyone,

This is going to be a noob question so I apologise in advance, but I have tried searching through the forum and online and not been able to find an answer.

My office has recently switched from vray to Corona and so far it has been great, however we cannot figure out how to match the vray frame buffer history functionality. I want to know if there is something I am missing or not understanding, I know how to resume from file with a cxr, however I want to be able to load my finished render file back into the vfb to then render a region, not for it to resume rendering from where I saved it. As it stands I seem to only be able to load the cxr and it starts rendering immediately and I have to cancel it which takes ages before I can then set up my region to render. If I save anything in the history tab of the vfb it is not there when I reopen the scene after closing. Am I doing some wrong?

Thank you for any potential help,
Matt

Title: Re: Region Render Help
Post by: romullus on 2019-09-12, 10:41:41

Hi,
you're not doing anything wrong, it's simply Corona has not such functionality yet. It was asked many times from the users and probably will be implemented at some point in the future, but nobody knows when exactly that could happen.

Title: Re: Region Render Help
Post by: mwg on 2019-09-12, 10:45:20

Damn, well thanks for taking the time to reply.