Chaos Corona Forum

General Category => General CG Discussion => Topic started by: Dalton Watts on 2016-06-17, 14:00:11

Title: Corona uses all cores but vray doesn't
Post by: Dalton Watts on 2016-06-17, 14:00:11

I don't know if this is the proper place to have an answer but here it goes: i just installed my second Xeon 2699 v3 on my Asus Z10PA-D8 and while Corona (and Cinebench) handle all cores (36) and threads (72) just fine while rendering, vray only uses ONE cpu. Setting affinity doesn't work as it reverts back to using one cpu even if i check the turned off cpu.

I'm using Windows 7 Ultimate x64. It scores 4376CB by the way :) Will i have to install Windows 8 or 10 to release all its potential? One more point in favour of Corona i guess...!

Title: Re: Corona uses all cores but vray doesn't
Post by: romullus on 2016-06-17, 14:19:58

Did you try to ask this on Chaosgroup forum? ;]

Title: Re: Corona uses all cores but vray doesn't
Post by: maru on 2016-06-17, 14:21:49

One solution is to use Corona.

Title: Re: Corona uses all cores but vray doesn't
Post by: Dalton Watts on 2016-06-17, 14:25:40

lol! Yes, that's THE solution :)