Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] I need help! => Topic started by: AVAV on 2016-04-21, 07:45:36

Title: Camera Tilt Shift
Post by: AVAV on 2016-04-21, 07:45:36

Hey Guys,

I've seem in some examples in this forum that people have been applying 'Tilt Shift' or correction to their camera through a Corona Camera Mod or something to that effect. But I cannot find that modifier in my list. Is there a special way to go about this? Or am I missing something obvious here?

Thanks for any advice in advance. This forum has been an excellent resource of information!

Regards,

Avav

Title: Re: Camera Tilt Shift
Post by: pdaniun on 2016-04-21, 08:03:58

Select the Camera Object in viewport, right click to show the Quad Menu and choose "Apply Camera Correction Modifier" (top, left quad)

Title: Re: Camera Tilt Shift
Post by: alexyork on 2016-04-21, 09:38:16

That is what you need to do if your target is not level. But the better way to do it (usually) is to make sure you use a physical camera and then go down to the Perspective Control section and use the Lens Shift tools. Note that these sometimes don't work in the viewport properly especially when using DOF.

Title: Re: Camera Tilt Shift
Post by: maru on 2016-04-21, 14:50:00

Either 3ds Max 2016+ Physical Camera, or select the camera and its target and put a taper modifier on them.

Title: Re: Camera Tilt Shift
Post by: AVAV on 2016-04-22, 03:21:38

Quote from: pdaniun on 2016-04-21, 08:03:58

Select the Camera Object in viewport, right click to show the Quad Menu and choose "Apply Camera Correction Modifier" (top, left quad)

Excellent, thank you very much, exactly what I was after!

I tried the other two methods also, cheers guys!