Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cecofuli

Pages: [1] 2 3 ... 106
1
Why not to use temporary the 3ds max "2D Pan Zoom mode" tool when you render IR in viewport?

2
Hello Yankee,

no, only the hard copy version is available =)

3
[RESERVED]

4
[RESERVED]

5
You can find the Material Library button on the Corona Renderer Official toolbar and in the TAB Renderer called "SCENE", in the "General Settings" rollout (^_^)

6
➡️ ➡️ ➡️  Corona - THE COMPLETE GUIDE  ⬅️ ⬅️ ⬅️


----------------------------------------------


----------------------------------------------

After four years of hard work, I am very proud to show you my second book 🥳.
"Corona - THE COMPLETE GUIDE" is the world’s first technical manual for Corona Renderer.
It's a volume created after more than twenty years of professional career in the 3D field, after six years of using Corona Renderer, and a close collaboration with Chaos Czech a.s..
Thank you so much to Corona Team for your support over the past years!

----------------------------------------------






7
We are very close...

 

8
Simple way: delete 3dsmax.ini and you will reset 3ds Max to the default state (do backup first)

9
[Max] General Discussion / Re: infinity mirror error?
« on: 2020-10-06, 15:36:44 »
I thin he didn't like to see so many mirrors =)

10
[Max] General Discussion / Re: infinity mirror error?
« on: 2020-10-05, 12:36:31 »
Hello renderbox,

this is correct. Since Corona is a physics based engine, as in real life, if you put two mirrors facing each other, this is what happens =)



The "solution" is to change camera angle.

11
Maru,

I hope you will like it (^__^)

12
Hello,

I am proud to announce the release of the book --- Corona - THE COMPLETE GUIDE--- .
The writing took four years and it would never have been possible without the Corona team support.




----------------------------------------------



----------------------------------------------



----------------------------------------------

13
Thank you =)

14
Hello,

I'm using a dual monitor setup and 3ds Max is on the Monitor 2.

(*1) Open FILE A and click render: the VFB is on Monitor 1. Click stop.
(*2) Move the VFB on Monitor 2 and click render again.
(*3) The VFB is on Monitor 2: it remembers its position. Good.

(*4) Now I open a new FILE B and click render: the VFB is on Monitor 1 again.
(*5) So, I need to move again the VFB on Monitor 2.

I think it's a bit annoying. Is is a feature or what?

Thank you =)



15
[Max] General Discussion / Re: Corona Scatter
« on: 2020-09-09, 16:42:06 »
We have no official info.
From rumors, we should see something in the end of this year...

Pages: [1] 2 3 ... 106