Author Topic: Bring scatter clones closer option  (Read 2377 times)

2022-06-02, 20:29:55

Mac3DX

  • Active Users
  • **
  • Posts: 147
    • View Profile
Hi Guys, would be nice to have an option to bring closer the clones inside the defined areas (splines). Sometimes you have a few clones, but they end up too far from each other. And if you size the spline down you mess with the clones.

Does it make sense?

2022-06-03, 11:50:31
Reply #1

Beanzvision

  • Corona Team
  • Active Users
  • ****
  • Posts: 3809
  • Bengamin
    • View Profile
    • Cormats
Hi there, Have you tried playing around with the near/far settings?

Bengamin Jerrems l chaos-corona.com
3D Support Specialist - Corona l contact us
Corona Uploader l Upload
Portfolio l Click me!

2022-06-03, 14:37:53
Reply #2

Mac3DX

  • Active Users
  • **
  • Posts: 147
    • View Profile
I think you didn't get the point. First, why don't we get exactly the numbers of instances set on count field? Finally, inside the scattered area I can't bring the clones close together, and if I try to reduce the spline, the instances go away.
We should have the option to make the instances close together from each other without changing the number of copies.


2022-06-03, 14:55:11
Reply #3

Beanzvision

  • Corona Team
  • Active Users
  • ****
  • Posts: 3809
  • Bengamin
    • View Profile
    • Cormats
This might just be a ''spline'' issue. When scattering without a spline the scatter amount seems to match as expected. In any case, we will need to look into it further.

Bengamin Jerrems l chaos-corona.com
3D Support Specialist - Corona l contact us
Corona Uploader l Upload
Portfolio l Click me!