17
« on: 2017-06-21, 16:47:33 »
Hello Everyone.
I hope someone can help. I have been running a few animation Tests in order to figure out the animation settings required and am not getting the expected results.
I have attached a 2 videos that shows the anti aliasing issues I am having , unfortunately the video compression makes it look better than it actually is and reduces the severity of it a little.
The issue I am having is that the anti-aliasing is just not crisp and has a lot show a lot of swimming and jittering, especially on the brick wall, pots and glasses. Since this TEST I have run other tests where I have reduced the GI vs AA balance to 8 and 4 as some posts suggests but that just seems to make the result worse instead of improving.
In my latest test(not the one attached) I used Light Portals which made quite an improvement but the anti-aliasing issue is still there, I did not attach that one as the compression made it difficult to see the issue. Each frame rendered at 1920x1080 with 300 passes and a Denoise amount of 0.6.
I am not 100% sure what other settings I should be tweaking to improve this, should I raise the GI VS AA balance? Change Image Filtering? More passes? light samples multiplier? Perhaps its not AA and rather GI that I am not understanding. or is this as good as it gets with Corona?
Any help would be greatly appreciated.
Thank you.