Author Topic: Anisotropy V Translucency  (Read 1214 times)

2022-09-22, 12:18:55

romullus

  • Global Moderator
  • Active Users
  • ****
  • Posts: 8779
  • Let's move this topic, shall we?
    • View Profile
    • My Models
I wonder if i'm the only one who constantly confuses translucency with anisotropy in the physical material? I think their placement in current UI is unfortunate - i've lost count how many times i intended to set or adjust translucency fraction, just to be puzzled few moments later why my material looks so weird (that's because you've set anisotropy instead of translucency, dumbass!). I wanted to submit request to spread those two parameters further apart, so there would be less chance to mistakenly adjust wrong parameter, but if nobody else have this problem, then i guess i'll somehow have to live with that.
I'm not Corona Team member. Everything i say, is my personal opinion only.
My Models | My Videos | My Pictures

2022-09-22, 17:18:56
Reply #1

maru

  • Corona Team
  • Active Users
  • ****
  • Posts: 12711
  • Marcin
    • View Profile
I can't recall any reports about it, but sure, if there are some votes for this, we can try to reorder the UI.
Marcin Miodek | chaos-corona.com
3D Support Team Lead - Corona | contact us

2022-09-22, 19:21:28
Reply #2

romullus

  • Global Moderator
  • Active Users
  • ****
  • Posts: 8779
  • Let's move this topic, shall we?
    • View Profile
    • My Models
That's why i created this topic, to see if there would be support for such request. I already had this accident twice today. Personally for me it's quite an issue, i've been working with physical material for a year, or two, basically since its introduction and i still can't get used to location of some UI elements. It's hard to believe that it's just me such unlucky :]
I'm not Corona Team member. Everything i say, is my personal opinion only.
My Models | My Videos | My Pictures