Corona Renderer for 3ds Max > [Max] Daily Builds

Corona Renderer 7 for 3ds Max - Daily Builds Discussion

<< < (2/126) > >>

Frood:

--- Quote from: shortcirkuit on 2020-09-22, 02:48:54 ---sectional or cut-through views

--- End quote ---

Check out tySlice meanwhile...


Good Luck




shortcirkuit:
Thanks - looked at this but it doesnt work to well


--- Quote from: Frood on 2020-09-22, 09:23:57 ---
--- Quote from: shortcirkuit on 2020-09-22, 02:48:54 ---sectional or cut-through views

--- End quote ---

Check out tySlice meanwhile...


Good Luck

--- End quote ---

jasond:
I've been waiting for 'corona slice' since it went on the trello list since at least 2017. That's a long time to keep pushing a feature :(

Though tyslice is better than the default slice modifier, it's nowhere near as feature-rich as vrayclipper. Corona decision makers... throw us non-arch/viz users a bone once in a while.

LorenzoS:

--- Quote ---throw us non-arch/viz users a bone once in a while.
--- End quote ---

Corona Slicer would be useful for archi/viz users too

jasond:

--- Quote from: LorenzoS on 2020-09-22, 14:40:16 ---
--- Quote ---throw us non-arch/viz users a bone once in a while.
--- End quote ---

Corona Slicer would be useful for archi/viz users too

--- End quote ---

Hehe true, I've seen lots of great arch/viz renders where a slice is used. Correction to my post.... throw us all a bone and at least try to get coronaslice implemented sooner rather than later :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version