Chaos Corona for Cinema 4D > [C4D] General Discussion

Gobo Lights

(1/2) > >>

LeSill:
Hello, folks.
I just saw a video of one of the Corona Masterclass sessions in which the instructor discussed using Gobo. Unfortunately, I couldn't pay attention and missed how to make a good gobo effect. I intended to utilize it today, but I'm not sure where to put the picture for the gobo effects when using an area light or a sector light. Do you know how to create the gobo effect and adjust the softness?
Many thanks!

Beanzvision:
For best results, use a standard C4D light, a standard C4D material and add your texture to the alpha channel. Assign it to the light and change the projection to flat. Turn off ''tile'' and adjust the scale if need be. One thing to note is that this will not show up with IR but it will with a final render. If you want IR you can use Cinema's IRR.

LeSill:
Thank you for replying. So, Nikos Nikolopoulos utilized this technique during the Archviz Masterclass? I'm not sure whether you saw it, but he was able to effectively manipulate the Gobos, etc.

Beanzvision:

--- Quote from: LeSill on 2024-04-11, 11:45:57 ---Thank you for replying. So, Nikos Nikolopoulos utilized this technique during the Archviz Masterclass? I'm not sure whether you saw it, but he was able to effectively manipulate the Gobos, etc.

--- End quote ---

I haven't seen it but feel free to share a link and I'll check it out. ;)

davetwo:
I know its been mentioned MANY times before, but I really feel that the ability to do this with cornona lights is a much needed feature. Pretty much every other engine can make sharp spotlights for this puropse. I'm really not sure why it seems to be in development limbo

Navigation

[0] Message Index

[#] Next page