13
« on: 2017-03-26, 13:04:43 »
i would like to request implementation of better memory management for pc with limited ram amount.
it is common problem when there is not enought memory when renderign with corona ; even with 32gb ram. now there is no option to tell corona not to use all available ram.
in this case cpu usage drops, because corona starts caching to disk, when memory not enough.
in my experience corona 1.5 uses almost all available ram (displacement turned off), and crashes (total pc 31.6gb ram of 32gb ram).i have read same experience on russian forum, that corona uses way more ram than vray.
it would be great to have option to set limit for ram memory corona to use ( as it is done in vray- dynamic geometry ; and low memory embree checkbox), so that computer does not run out of memory.
this option should make corona load information on rendering time, not at one before rendering.
still i am not using corona on daily basis, because of this memory management problem. because i dont know if corona renders my project fine, or it runs out of all my memory and crashes.