Chaos Corona for Cinema 4D > [C4D] I need help!

New User needs help / Normal Maps barely visible

(1/2) > >>

Anthe.cr3:
Hi there!

Long story short, been working with Blender for 3 years now, and just started out with Corona in Cinema4D, i noticed some issues concerning effect Normal maps have. They are barely visible (in my case)


I posted 3 Pictures, one is the (desired) result in Blender Cycles with the same Normal map, one picture with the result in Corona, and a third with the Corona Node Editor settings.
I tried to have similar lighting and angle for the screenshots


Troubleshooting:

-I have already checked if the Green needs to be inverted

-I Plugged the Bitmap to a Normal and this node then to the Bump channel

-I used Linear colorspace opposed to srgb or embedded Profile

-It's a DirectX Normal Map

-How can i adjust the Strength of the normal map in general?

-scaling of the model (Tire) is true to real world scale

I am sorry, if this is a repeated question, but i couldn't find any solution yet.

Thanks in advance!

Philw:
What percentage is your bump strength set to in the main material node?

Anthe.cr3:
There is no Bump map plugged into the Normal Node, only the Normal Map Texture.

So changing the Strength under "Additional Bump Mapping" doesn't change anything for me.


See the Screenshot attached for more Info on my settings.


Thanks!!

mmarcotic:
Hello,

inside the Legacy material, in the Bump tab, there is also a "Strength" parameter. This is, by default, set to 10%. See if changing that helps.

Thanks,
Jan

davetwo:
This:

Navigation

[0] Message Index

[#] Next page