Messages

1

[Max] Daily Builds / Re: Corona Renderer 8 for 3ds Max - Daily Builds Discussion

« on: 2021-10-13, 16:03:16 »

Here's the proof that sRGB switch is working as intended. Just remember that you need to look at RGB values, not at HSV, because for some strange reason Corona shows the former with respect to sRGB switch, but the latter are always displayed in linear.

Oh, I think I got it. HSV is not always converted to RGB correctly. But RGB and sRGB in the color picker and corona color picker are the same colors. Thank you very much!

2

[Max] Daily Builds / Re: Corona Renderer 8 for 3ds Max - Daily Builds Discussion

« on: 2021-10-13, 14:30:56 »

Why are the colors in corona color picker as if with the wrong gamma? I enter the color data (HSV) 147/51/53 and in the standard color picker - the color is what you need.
When I do the same in corona color picker, the color is dark. But if I add Corona Color Correct and enter gamma 2.2 into the frame instead of the standard 1.1, then the color matches.

It seems that the corona Color Picker does not put gamma 2.2 by default.
I don't know if it's a bug or I just didn't understand what I did wrong. But this has not been observed before. The colors in both color pickers were the same.

here's your answer (look at the attachment).

No, I tried turning on the srgb switch. Unfortunately, this does not solve the problem. Also gamma 2.2 is enabled in the settings, Affect color selectors/AFFECT Material editor are also enabled.

The colors in different color pickers differ, despite the fact that the above parameters are enabled. If you turn it off, there is an effect, but in the opposite direction, the colors become even darker.
I am almost sure that the exposed gamma 2.2 does not apply to the Corona Color Picker. That's why the colors exposed through it are darker. And if you add a gamma, 2.2, to the color displayed in Corona Color Picker, then everything becomes correct.

3

[Max] Daily Builds / Re: Corona Renderer 8 for 3ds Max - Daily Builds Discussion

« on: 2021-10-13, 06:46:11 »

Why are the colors in corona color picker as if with the wrong gamma? I enter the color data (HSV) 147/51/53 and in the standard color picker - the color is what you need.
When I do the same in corona color picker, the color is dark. But if I add Corona Color Correct and enter gamma 2.2 into the frame instead of the standard 1.1, then the color matches.

It seems that the corona Color Picker does not put gamma 2.2 by default.
I don't know if it's a bug or I just didn't understand what I did wrong. But this has not been observed before. The colors in both color pickers were the same.

4

Chaos Corona for Blender / Re: Blender Exporter v3 released

« on: 2020-12-24, 00:08:14 »

True...