about the output size, lets say I have 2 camera named cam1 and cam2.
now I enable both camera's setup by pressing the setup enable button. then, in cam1 I change the output width to 2000 and output height to 1000.
ok, now I go to the cam2 setup, I see that the output width value is 2000 and the height is 1000 too. its value is changed to last selected cam output width/height value, and this is the correct behavior. it will has its own value only if I changed the value.
the point is you have to change the value of cam2 first to make the cam2 value independent (not following the cam1 or generally following last selected cam's value).
hope you guys understand hahaha :)
And sometimes I receives an script-error rapport when trying to render with "exclude" activated.
can you send me the error report showed in maxscript listener?
edit:
oh mann, I didn't read your words carefully. you guys asked me about ratio spinner incorrect function and I replied with stupid unrelated long explanation.
then you must remember that you have to be very patient and tolerant when having a conversation with me :D
ok, its fixed now. I have replaced the attachments on the first post. check it out :D