Corona Proxy WRONG PIVOT - (On Load from file - replace)

[sk-films]

Found a problem with Corona Proxy.

To recreate bug:

1) Create empty proxy
2) Load from file (Let's say small sized tree) - All works fine
3) In same proxy Load from file (Taller tree) -> Now the pivot might be in the middle of the tree

!!!Second tree pivot is correct if loaded in empty proxy (as step 2)

[cecofuli]

Everything is ok here ( I tried with a teapot with different segments).
I think your Proxy have some problem with the Pivot.
Try to export the geometries again, with the Pivolt at 0,0,0 (remember to  use "Reset X From)

[sk-films]

Following your logic the second tree should always load in the middle.
However if I load it first (in empty proxy) it appears right on ground.

Regarding different teapot segments - didn't get this. It's not due to segments - it's due to bounding box size.

[sk-films]

Right - a small correction:

The second proxy is actually offset after loading.

BUT!!! It happens somewhere at proxy creation stage.
As tree is actually in 0,0,0 (Pivot as well)
Rotation all 000
Scale at 100%.

But after creating the proxy and loading it - it acts like pivot is in the middle of tree.

[Frood]

Have you tried what cecofuli mentioned? Most important:

(remember to  use "Reset X From)

Good Luck

[sk-films]

That's what I'll try for next project. As all setup now.

But anyway it acted strange here.