616
[Max] I need help! / Re: Corona 5 - 2.5D Displacement on Curves
« on: 2019-11-07, 21:11:15 »
I think the answer is more geometry as suggested. Here I've added 25 horizontal connects to a section, the bit at the top before it meets the white brick and the artifcats are significantly reduced, compared to the section below and white brick above. For some reason though I was under the impression Corona's displacement didn't really on geometry subdivision. For what it's worth, I'm not using autobump either - should I be?
Just to add to this, does anyone know why textures lack detail in Corona - i find this a lot. The brick for example, the crops I'm sending are from a 6k render. The texture I'm using is 8k.
Attached a 1:1 crop of the texture, but I can never seem to get that detail through in Corona. In this instance the texture is applied via a Corona Bitmap node with filtering set to 0.01 and bicubic smoother
Just to add to this, does anyone know why textures lack detail in Corona - i find this a lot. The brick for example, the crops I'm sending are from a 6k render. The texture I'm using is 8k.
Attached a 1:1 crop of the texture, but I can never seem to get that detail through in Corona. In this instance the texture is applied via a Corona Bitmap node with filtering set to 0.01 and bicubic smoother