Messages

1

[C4D] I need help! / Re: Fireflies

« on: 2022-11-23, 17:17:46 »

Hi,

Discovered the issue. I had inadvertently added anistrophy to the material and the bump map was distributing it over surface making it look like fireflies.

Thanks for your help.

2

[C4D] I need help! / Re: Corona Slicer

« on: 2022-11-23, 11:23:30 »

Hi all,

Sorry for delay in reply. I wasnt able to resolve the Slicer problem easily. In the end I used exclude to remove elements which seemed to be causing issues.

Thanks for your comments

Richard

3

[C4D] I need help! / Fireflies

« on: 2022-11-23, 11:21:09 »

Hi,

I've been looking through threads and cant see an answer for this but happy if someone can point me to it.

I'm getting fireflies on two materials in an interior shot. I've tested to see what is causing the issue and it seems to be geometry spotlights with a corona light material applied. The intensity of the light material is at 800 lowering this amount doesnt seem to effect the fireflies but if I turn them off then they disapear. The scene has a corona sun and an HDRI as it is both interior and exterior of architecture. I am using a low pass count under 30 for speed but increasing this doesnt seem to effect it. Ive tried altering the performance settings in render settings with out success.

I won't be able to send a scene file as it is cionfidential.

Would be great if someone could help

Richard

4

[C4D] I need help! / Corona Slicer

« on: 2022-11-03, 16:25:15 »

Hi
 
Just started using Slicer material on a project but Im getting Texture corruptions. See attached file of doors in a wall at very low rez. Is there a work around or is tere known issues with certain types of geometry, booles, symetry, mograph etc

Any help would be great

Thanks

Richard