Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PROH

Pages: [1] 2 3 ... 82
1
Hi. It's not only "Plain White Sheer 3068925 20cm" that can't be applied. It seems to be ALL "Sheer" materials - at least the new ones.

2
Totally agree with dj_buckley. Toon or Sketch shader is an absolutely "must have" for architects and related professions. That's why I've requested this for several years.

3
You should also deactivate the exposure in 3ds Maxs environment panel, and use Coronas exposure only.

4
Then you're lucky. Happens a lot here.

5
Because of this I haven't changed my subscription yet, and still wondering what to choose. But it sure would be nice to know how to do it correct without loosing my nodes.
I can find thr ticket ID sometime later if you still need it.

6
Yes  I did. And I referred to the advices from forum.

7
@Tom - Unfortunately Chaos support just gives you a link to do it yourself. So that advise doesn't seem to be right, or maybe Chaos support need to be informed better?

This is absolutely Chaos!

8
Are you trolling me?

9
ALL other usecases!

10
I don't think your example is used as often as ALL other usecases together. And your result could be done in other ways (f.x. by baking the displacement into the mesh), whereas the suggested behavior can't.

11
ALL materials that I would use with triplanar.

For example ground materials as dirt with small stones on curved terrains where planar or box-mapping will give unwanted results.
Or when importing lots of objects without propper mapping, where triplanar gives a useable result in a short time.
Or with organic shaped objects without proper UVW.

I can't honestly imagine one single case where the current behavior is wanted. To me this is a pure theoretical solution.

12
Maru@ - I don't think anybody are trolling you. It just doesn't make sense to ask the obvious. Read the comment again, and you'll get the answer. Personally I need this every time I use triplannar with a material that uses displacement. I've NEVER needed the current behavior.

Regards

13
[Max] I need help! / Re: Black environment
« on: 2022-10-31, 16:44:29 »
Hi. This reminds me of a case I had, where the corona color map rendered black when set to pure white (256, 256, 256). The problem was solved by setting the color to 255, 255, 255.

Hope it helps

14
Hmm.. still can't get the toolbar icon to "remove" (shift + click), so I'm just using hotkeys.

Edit: With v 0.4 everything works as expected. Thank You :)

15
Tanks for bringing this up again,  and + 1000 for your suggestion.

Pages: [1] 2 3 ... 82