[solved] Corona pattern. Automatic height

[lupaz]

Hi,

Shouldn't "automatic height" keep the height proportionally correct regardless of mapping or tiling?
In this video I used a small cylinder as the node. But when on the pattern, it gets distorted in height.

[TomG]

Can depend on your source object's XForm and similar (that is, the one being repeated as the Pattern).

is the bit that explains the use of pattern height.

[lupaz]

Ok. Thanks Tom. I'll try resetting Xforms.

[maru]

Hi Lupaz, do you have any progress here? Is it working fine after xform reset?

[lupaz]

Yes. It worked.
Not sure why though, cause the cylinders where a standard Max geometry that I rotated in subobject level at one point, keeping 90 degrees always.
Thank you for checking in.

[maru]

Cool, thanks for confirming!