11
« on: 2019-06-18, 16:02:11 »
Cheers guys,
I use clearcoat material quite often and it is not that big of a deal.
There are two ways I set them up.
1. Stacked Material
-Create your base material as you wish and apply it to your mesh
-Create the clearcoat as followed:
-disable diffuse and enable reflectance
-set the IOR to 999
-enable opacity and use the c4d fresnel shader in the texture slot, set the value to your liking (1.33-1.5 works in most cases for me)
-apply your coat material to your mesh and make sure it sits after your base material (from left to right)
2. Layered Material
-Create your base material as you wish
-Create layered material and put your base material to the base material slot
-Create the clearcoat as followed:
-disable diffuse and enable reflectance
-set the IOR to 999
-put your clearcoat the layer1
-use the c4d fresnel shader in the amount texture slot, set the value to your liking (1.33-1.5 works in most cases for me)
If something doesn't work, gimme a hint and I'll check it.
Cheers...