Parameters of CoronaCamera doesn't work

[Riccardo.3D]

When I change the set of camera (ISO, Shutter Speed, F-Stop) nothing change in the render.
Is it possible to set these parameters in CoronaCamera or it's better to use a Standard Phisycal Camera?
Thanks

[James Vella]

both should work just the same (appearance wise). If using Corona Camera have you checked the overides are on in the modifier?
Physical Camera uses Exposure Control in the Environment settings. They are setup slightly different.

Easier if you show some screenshots of your current setup

[Riccardo.3D]

Here is the screenshot of my camera setup

[hurrycat]

You have to have Photographic Exposure enabled on the VFB. You can add it if its not there.

[James Vella]

As hurrycat said (attached)

[Avi]

Please check out this tutorial from this timestamp (2:50).

I hope it helps.