Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] General Discussion => Topic started by: dsolod on 2015-06-02, 05:41:24

Title: "Wire Parameters..." inside Corona Materials
Post by: dsolod on 2015-06-02, 05:41:24

Hello,
I would like to Wire some Noise parameters which was set up as Diffuse Map.
But it looks like Corona does not let me to go so deep when I try to reach the Noise Level.
Is it a known issue and is there any workaround about it?
Thank you!
Dmitry

Title: Re: "Wire Parameters..." inside Corona Materials
Post by: maru on 2015-06-02, 14:28:02

Hello, it looks like there is a problem with this for every Corona mtl. The temporary workaround would be:
-create a new "standard" (non-Corona) material
-instance the noise/whatever map from Corona mtl into this material's diffuse
-wire this
-apply the Corona mtl again

Title: Re: "Wire Parameters..." inside Corona Materials
Post by: dsolod on 2015-06-03, 03:46:29

Great!
Thank you for the tip maru!