Chaos Corona Forum

Chaos Corona for 3ds Max => [Max] I need help! => Topic started by: twoheads on 2021-05-30, 21:51:06

Title: corona bitmap U/V Tiling linear float controller
Post by: twoheads on 2021-05-30, 21:51:06

hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: twoheads on 2021-05-31, 14:29:36

hello team,

Any advice?

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: romullus on 2021-05-31, 16:45:08

Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: GeorgeK on 2021-05-31, 17:11:48

Quote from: romullus on 2021-05-31, 16:45:08

Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.

I was equally confused at first, these two control tilling mode for U&V. So I am afraid this might need some further looking into.

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: GeorgeK on 2021-05-31, 17:12:45

Quote from: twoheads on 2021-05-30, 21:51:06

hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH

It seems that way, I am reporting it for further assessment, thanks!

(Report ID=CRMAX-650)

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: twoheads on 2021-05-31, 18:27:11

When you connect linear float to TilingU and TilingV  it'll change tiling mode (values 0-no tiling, 1-repeat tiling, 2- mirrored tiling, 3-clamp).

thanks

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: romullus on 2021-05-31, 19:33:06

Now, when George did show full UI, i think you need to plug controller to uvwScale, but obviously you can't plug float controller to the slot that is expecting point3 controller. So you need to pick some handy controller from point3 group and it should work.

Title: Re: corona bitmap U/V Tiling linear float controller
Post by: twoheads on 2021-05-31, 20:36:27

indeed it works, It should be TCB Point3 controller

thanks romullus