Author Topic: corona bitmap U/V Tiling linear float controller  (Read 1656 times)

2021-05-30, 21:51:06

twoheads

  • Active Users
  • **
  • Posts: 261
    • View Profile
hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH


2021-05-31, 16:45:08
Reply #2

romullus

  • Global Moderator
  • Active Users
  • ****
  • Posts: 8779
  • Let's move this topic, shall we?
    • View Profile
    • My Models
Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.
I'm not Corona Team member. Everything i say, is my personal opinion only.
My Models | My Videos | My Pictures

2021-05-31, 17:11:48
Reply #3

GeorgeK

  • Corona Team
  • Active Users
  • ****
  • Posts: 838
  • George
    • View Profile
Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.

I was equally confused at first, these two control tilling mode for U&V. So I am afraid this might need some further looking into.
George Karampelas | chaos-corona.com
Chaos Corona QA Specialist | contact us

2021-05-31, 17:12:45
Reply #4

GeorgeK

  • Corona Team
  • Active Users
  • ****
  • Posts: 838
  • George
    • View Profile
hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH

It seems that way, I am reporting it for further assessment, thanks!

(Report ID=CRMAX-650)
« Last Edit: 2021-05-31, 17:29:15 by GeorgeK »
George Karampelas | chaos-corona.com
Chaos Corona QA Specialist | contact us

2021-05-31, 18:27:11
Reply #5

twoheads

  • Active Users
  • **
  • Posts: 261
    • View Profile
When you connect linear float to TilingU and TilingV  it'll change tiling mode (values 0-no tiling, 1-repeat tiling, 2- mirrored tiling, 3-clamp).

thanks

2021-05-31, 19:33:06
Reply #6

romullus

  • Global Moderator
  • Active Users
  • ****
  • Posts: 8779
  • Let's move this topic, shall we?
    • View Profile
    • My Models
Now, when George did show full UI, i think you need to plug controller to uvwScale, but obviously you can't plug float controller to the slot that is expecting point3 controller. So you need to pick some handy controller from point3 group and it should work.
I'm not Corona Team member. Everything i say, is my personal opinion only.
My Models | My Videos | My Pictures

2021-05-31, 20:36:27
Reply #7

twoheads

  • Active Users
  • **
  • Posts: 261
    • View Profile