Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NicoB

Pages: 1 ... 4 5 [6]
76
[C4D] General Discussion / Re: AA problems and noise
« on: 2014-10-06, 15:33:08 »
..:)
and another thing;

I dont know how you light the pending light.
Try placing sphere lights outside or inside the bulbs and exclude them from the bulbs.
On the inner part of the bulbs just place the "light material", but not to strong.

Maybe this helps with the ceilling part..

77
[C4D] General Discussion / Re: AA problems and noise
« on: 2014-10-06, 15:29:48 »
..or you can try to just place two plane lights into the openings (without sky,sun,IBL...)

78
[C4D] General Discussion / Re: AA problems and noise
« on: 2014-10-06, 15:27:57 »
Hi,

I think your light (from the outside) is to strong.
I have seen this AA-"problem" in one of my scenes..

Try turning this light down (Even in the bedside-lamps) and get more "fake"-light into your scene.
Some base lighting should be possible with some openings behind the camera (just indirect light).
Maybe you can put the wall´s behind the camera a bit down an try it.

Hope it helps.

Another thing is to very carefully take a look at your maps/textures and how they are filtered.
(Bump works good with standart MIP)..

Cheers,
Nico

79
Hi,

I have some kind of the same problem.
Can you tell, what you have done to get
the render speed back when using
max photometric lights?

Turning light shape to sphere causes the light
to get Off in my scene..(?)

Cheers,
Nico

80
Hej, quick answer from the boss :), thank you.

ok, I was thinking to make the same fault over and over again.
So i am looking forward to the next, fixed built of corona where i can put all the ies-files.

I´m very happy you made this one (corona).
Everything gets more complicated, so we do need a tool which is easy to use..

Thank you, best regards
Nico

81
Maybe someone could upload a scene with 10-20 IES ligths in it.
This will explain how to use them.

It would help a lot...

82
Hi,

my problem:
I do use IES Corona lights and the noise in the light shape does not want to get clear (it renders fast, but the noise in the lights wont get away).
When i am using 3dsmax lights and setting everything, so corona renders the ies, the rendertime "explodes".

So:
Can somebody tell me to get the best and fastest result with IES-Lights in corona?
Maybe some description about what steps and settings to work around?

I think this will safe one near deadline..

Thank you!

Pages: 1 ... 4 5 [6]