Need some advice from more experienced folks about settings and render times

[rafpug]

Yes Corrents

I wanted to confirm if the noise was gone!

Rendering time you can also halve if you adjust the values ​​of the secondary solver depending on your scene

You need to do 3 4 tests on a sample with the Crop and calculates the time you!

Greats
Raf

[Correntes]

Thanks for the input rafpug, can you explain a little your process to optimize a scene ?

[rafpug]

EDIT

I used a value 40 in Lights samples Multiplier. I let the crop run for 1.5 min (33 passes) and I got more or less the same results that 20 light samples multiplier cooking for 2.5 min.


Is there any drawback in use always 40 in lights samples multiplier ?

best not to overdo it too  ^ _ ^

[rafpug]

Thanks for the input rafpug, can you explain a little your process to optimize a scene ?

sure Correntes
also a board uses the method PT+HD which is much faster both in the rendering of the image in the rendering time

The setting of secondary solver depends from one scene to the other one and go calibrated.

In yellow the values ​​that you should not change

The Next
Raf

[Correntes]

Thanks rafpug


What about the ones I can change, what they do ? And what the guidelines to change them ?

[rafpug]

Hello Correntes

1 Steps -You can do a test checking the time of the first passes?

...Time Limit

[rafpug]

Thanks rafpug


What about the ones I can change, what they do ? And what the guidelines to change them ?

For explanations about the settings of the values, you have to ask the staff because they are very professional.

more info here:
http://corona-renderer.com/doc/