1
[Max] Corona Goodies - User Contributions / Re: Free models repository
« on: 2022-05-30, 17:32:19 »
Unfortunately all MEGA links are dead.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Qnap TS-1277. The initial idea was to load all from the Nvme RAID 0 (proxies and textures mainly) but since we have most of the models on the RAID 5 we usually keep our model asset textures there so loading usually happens from the 2 raids (nvme and HDD raids) and the single ssd's.I realized my mistake with keeping all files only on HDDs. Just ordered QNAP QM2-2P-344 and two Samsung 970 EVO Plus 2 TB today. I am planning to use it in RAID 1 for both current project files and textures, hdri's proxies etc. Is is a good or bad idea?
My Nas setup is as follows:
1. 6x10TB Ironwolf Drives in RAID 5 (for models, assets, backup of old projects, photoshop assets, etc...) - Drive bays of the NAS
2. 2x1TBSamsung Enterprise sata SSD's 2.5" no RAID (just for textures) - Drive bays of the NAS
3. 4x2TB Samsung M2 970 Evo Plus nvme SSD's in RAID 0 (for all current projects and project-related files) - They are all stacked up on a QM2 Quad nvme SSD card in the PCI-E Gen 3x8 slot of the NAS
4. 1x512gb Samsung M2 860 Evo sata SSD's in RAID 1 for the NAS operating system (M2 slots on the motherboard of the NAS)
I don't use caching haven't tried it to be honest but I know a few people who tried it and had problems with it. Especially when you use read-write cache and when the SSD's get filled up. They tend to become super slagish and start affecting the network badly.
We also use both HDD's in raid 5 and Nvme SSD's in raid 0