corona bitmap U/V Tiling linear float controller

[twoheads]

hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH

[twoheads]

hello team,

Any advice?

[romullus]

Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.

[GeorgeK]

Did you try to connect one slot below to "tilingU" and "tilingV"? I don't have Max to test it now, but i think the names speaks for themselves.

I was equally confused at first, these two control tilling mode for U&V. So I am afraid this might need some further looking into.

[GeorgeK]

hi guys,

Stupid question but is it just me or there is no way to plug linear float controller to U/V tiling slot as it's possible in 3dsmax bitmap?

cheers
TH

It seems that way, I am reporting it for further assessment, thanks!

(Report ID=CRMAX-650)

[twoheads]

When you connect linear float to TilingU and TilingV  it'll change tiling mode (values 0-no tiling, 1-repeat tiling, 2- mirrored tiling, 3-clamp).

thanks

[romullus]

Now, when George did show full UI, i think you need to plug controller to uvwScale, but obviously you can't plug float controller to the slot that is expecting point3 controller. So you need to pick some handy controller from point3 group and it should work.

[twoheads]

indeed it works, It should be TCB Point3 controller

thanks romullus