1
[Max] I need help! / Re: Discrepency between Beauty and Light Mix
« on: Today at 13:49:17 »
Ticket #246345 scene is confidential
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
DCC is Digital Content Creation or in this case Creator - ie, 3ds Max or C4D with associated version number :)
Hey, can you try with Corona 11 HF 2, just to be sure? because there were some changes related to color and removal of gamma operator.
Corona and DCC version?
I always found this to be the case as well, although very minor, so I never really even bothered to do PS overlay to check. I thought it's byproduct of some order-of-operation or layering method, etc..
+1 For this.
If corona wire had a way to just do profiles and not all edges it would be absolutely ideal for rendering elevations. Im certain ive seen tons and tons of this same request for the past ten years. If you did it, it would likely make a ton of people very happy!
I will leave Juraj to comment on his workflow :) I have tested something similar this last week though, using ComfyUI, and I can say that trying to do "face improvement" at 512x512 does not work, it just uglifies things :) For me I had to take a crop of my test image which ended up being 374 x 669, upscale it through a 4x upscaler to 1496x2672, then pass that through the Realistic model with 0.49 denoising, and then it improved clothes and faces. Trying to do that on the original crop with no upscaling just made things worse - so in the way I had things set up, a) you are not limited to 512 at all and b) 512 makes things worse.
This may be dependent on GPU memory though.
For interest, this was on a 4080 laptop GPU with 12GB memory, with similar performance seen on a 3070 Ti desktop. It was about 60 seconds to process the crop (that is to upscale it with a face sensitive upscaler, and then feed it through the model, combined in that time)
upscale it through a 4x upscaler to 1496x2672
ok, it could work, but I noticed that on the edges of the roof it would leave a void in the pattern...also I can't rotate, move, scale or overlap the tiles.
Instead another system to have more control and be able to place more types of stones (being very random even if similar) and above all to be able to cut without leaving holes on the edges?
if "avoiding user mistakes" is THE strategy - was anything done about Tone Curve after this thread:
https://forum.corona-renderer.com/index.php?topic=40616.0
an updated tooltip or something?