Corona Renderer IR is wrong

[Dimsn555]

Hello!
I observe such an effect, There is one thing in the viewport, Interactive Render shows the model without affecting it with joints

помогает только перезапуск IR

[Beanzvision]

Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.

[BigAl3D]

I don't know about you, but I still get the problem of the IR or IV not updating and have to hit Stop and re-enable it. did you start flat, move your joints and THEN it still showed flat?

[Dimsn555]

I don't know about you, but I still get the problem of the IR or IV not updating and have to hit Stop and re-enable it. did you start flat, move your joints and THEN it still showed flat?

from the very beginning, everything was fine. After I do something with the model, move the joint or just rotate the model, it becomes flat. In order for it to look like folded again, you need to restart the IR.

[Dimsn555]

Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.

here is the scene

[Beanzvision]

Hi there, are you able to share your scene with us so we can investigate further? I have tried to recreate this but I have not been successful.

here is the scene

This file is corrupt. Can you please ensure you are uploading a .c4d file?

[Frood]

This file is corrupt.

It's just a 7zip file without extension. Inside there is the C4D file (and two textures).


Good Luck

[Beanzvision]

This file is corrupt.

It's just a 7zip file without extension. Inside there is the C4D file (and two textures).


Good Luck

Ah, you're right! Thanks Frood :)

[Dimsn555]

Friends, what do you say? You have a scene displayed normally?

[davetwo]

Just teststed in (Mac R20).
Viewport rendering did indeed show it flat. Then I used the corona IRR and that showed the box in its correct folded state.

Weirdly when i switched back to viewport rendering that was now showing correctly too.

I deleted the materials and it went back to being flat again.

So yeah, something is not refresing as it should.

[Dimsn555]

What should I do now?
I have all models made this way , behave like this . Before that, I used Octane render, there was no such thing.

[Dimsn555]

And how to make hotkeys for these commands "Stop" and "Start IR"

[Beanzvision]

Nice font you're rockin there! ;) As for this, I do not think it's possible. But hopefully, someone will correct me.

[burnin]

works w/o issues on windows10, crn v8 rc3, c4d 25.117  (I just had to localize textures)

---------------------------------------------------------------------------------------------------------
PS
shortcuts are edited/made via "Command Manager"

[Beanzvision]

Thanks burnin'