Messages

1

Hardware / Re: Dual Xeon E5-2670 or i7-5820k

« on: 2016-05-22, 23:04:38 »

Asrock EP2C602

2

Hardware / Re: Dual Xeon E5-2670 or i7-5820k

« on: 2016-05-22, 22:24:29 »

Juraj thanks for clarifying this turbo boost matter. I got confused because in my rig cpu-z sometimes reports wrong cpu frequencies like lowest possible frequency when all cores are engaged. Eventually I compared corona benchmark results with mine and all seems ok - always getting like 1:37.

Btw, did you buy one of those Facebook-servers going for 70 dollars each :- ) ? I was looking at it too haha.

Exactly - very happy with purchase. This duo even slightly outperforms gtx970 in blender cycles rendering speed. The hardest part was getting the motherboard though which is the most expensive part of the rig.

3

Hardware / Re: Dual Xeon E5-2670 or i7-5820k

« on: 2016-05-22, 14:40:45 »

-2P 2670 v1 = (all-core turboclock) 18 520

Sorry for ressurrecting an old thread but now that I got 2x E5-2670v1 I am exploring ways to squeeze as much juice as I can from them. Juraj could You elaborate a bit about possibility of running all cores at turbo frequency - since You seem to know the topic. Is it motherboard dependent (my mb seems to prevent all tweaking expect for ram) or could it be enabled somehow in operating system?

4

[C4D] General Discussion / Cinema R14 support

« on: 2015-09-14, 11:44:38 »

How long are you planning to maintain support for cinema r14? I work on blender but since there won't be plugin for it I am eager to invest in cinema r14 (I found cheap offer). I don't want to buy software (for ability to render in corona with realtime preview only) just to find it obsolete in few months time.

5

Corona Standalone / Re: Standalone requests

« on: 2014-02-27, 07:47:04 »

My requests are the same as elnino's:

- CoronaSky
- CoronaMixTex
- Round Corners

and most of all: hdri rotation and strenght setting

6

[Max] Resolved Bugs / Re: corona windows vista 64 crash

« on: 2014-02-17, 14:55:48 »

 Thanks a bunch Keymaster. The build you provided works great.

7

[Max] Resolved Bugs / corona windows vista 64 crash

« on: 2014-02-16, 14:27:23 »

I have following problem: when I hit render (F12) or choose material tab in blender (I'm using blender-corona exporter) I get an error: "unable to find entry point for GetActiveProcessorCount procedure in kernel32.dll library". That occurs in vista 64bit. In windows 7 everything works fine. I asked this question in dedicated thread at blenderartists but was redirected here as it's seems like corona standalone issue rather than exporter.

8

[C4D] General Discussion / Re: Corona for Cinema 4D started

« on: 2013-07-02, 22:29:36 »

Will plugin support cinema r13 or r14 only?