Chaos Corona for Cinema 4D > [C4D] General Discussion

opacity mask problem

<< < (2/3) > >>

mitchino:
I've attached a zip file with a c4d file and an opacity map.

I just cannot figure out why this is happening.

mitchino:
How the file renders. The problem only visible on the cone.

mitchino:
Here's the problem with a newly created texture. Same material applied to a sliced cylinder primitive using cylindrical projection, and a plane using flat projection.

The cylinder does not show the edge problem, the plane does.

In fact the problem shows up on every mesh I've tried except a cylinder.

Beanzvision:
Hi, what happens if you enable "Clip" in the opacity channel? ;)

mitchino:
tried that - the soft edge is replaced by a hard edge

Navigation

[0] Message Index

[#] Next page

[*] Previous page