Chaos Corona Forum
Chaos Corona for Cinema 4D => [C4D] General Discussion => Topic started by: masterzone on 2022-08-30, 18:11:08
-
I recently bought a MacBook Pro M1 with top performance config.
I tried to make some (CPU) stress test with my iMac i9 10K.
With a simple cinebench the performance are the same, around 13.000 cinebench points. Very good! So happy.
But with Corona Render 8 the performance are different, I noticed that the iMac i9 uses the 98% of the processor instead of M1 that uses only 75-80% during render. And make the M1 a little bit slower. (With corona render engine)
With the cinebench internal render engine on both computers I see 98% of power but corona seems doesn’t uses all M1 cores and doesn’t reach the 98%.
Why?
-
I have a Mac Studio 20c with 128 Gb ram. I noticed that on renders that take a lot of ram, close to 128 or even more and swapping processor speed lowers to less than 1950% to around 1600-1700%. 1960% is usually maximum.
-
I tried to render simple scene too and not only huge scene...and the processor is near 80% of total rendering power instead of the Cinema4D standard rendering engine that go up to 95% of total cores...
Seems Corona Render has some issue on M1 processor....
But if you render a standard scene, not huge scene...what is your render percentage about Cinema4D + Corona? Are you reaching the 1960% all the time?
-
I don't check this often but I saw also that at times CR renders at 80%. But recently my Studio 20 cores does render at 1960% when I check.
-
mmm thanks for your time...I hope to hear some from developers...