Corona Renderer for 3ds Max > [Max] Daily Builds

AVX load issue during rendering

<< < (2/2)

BVVV:
In the dual 8280, the absence of AVX load increases the temperature by 4-10 degrees

Juraj:
That is natural and expected though. Your CPU is being utilized 6more percent and runs at +200 MHz (at minimum).

You should have faster rendering time. The temperatures are very low anyway, these CPUs can run 90deg just fine.

maru:

--- Quote from: BULUW on 2021-07-26, 12:23:01 ---Higher CPU clocks means higher temperature.
The frequency that was originally controllable is now uncontrollable. Rendering is more stressful than a single-load CPU, which is not good news for hedt.
BTW...I didn’t complain about the developers, just reported a problem,sorry for misunderstanding

--- End quote ---

I don't think the frequency is uncontrollable, and I don't think this is a problem at all. Software like Corona cannot make your CPU go into some "uncontrollable frequency". Your CPU will process the given tasks at the best possible performance. If you are getting too high temperatures, it is not a software issue.

Navigation

[0] Message Index

[*] Previous page

Go to full version