Chaos Corona for 3ds Max > [Max] General Discussion
Big Ask...
airflow:
Could some kind soul please document how to go about setting up an interior walktrhough using PT and Hd.
It would be a massive help to get me more upto speed.
airflow:
Ok maybe I should try to show you where I am stuck. I have tried PT primary PT secondary and managed to get a good clean render with no flicker. But that was just an exterior object that was moving. I am not sure if this would work for an interior walkthrough. I did a test with PT primary and HC secondary, but was not too sure how to set it up to do the cache pass. What i got was pretty bad flicker. Any help would be hot. Will post a scene if I can get some help.
Thanks in advance.
Ondra:
Hi,
have you tried saving the GI (rendering 1 frame with save GI checkbox on), and then reusing it (using other frames with load GI checked)?
airflow:
I will try that. Its a long walkthrough so I am not sure how well it will work out, but I will render over night and see what I get in the morning.
Ondra:
It is not much view-dependent, unless you push it to limits (walking across several rooms)
Navigation
[0] Message Index
[#] Next page
Go to full version